Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Switch Continuity Test
Disconnect appropriate power window switch. Using an ohmmeter, check continuity between specified power window switch terminals with power window switch in specified position. See POWER WINDOW SWITCH CONTINUITY table. See Fig 1 . If continuity does not exist at specified terminals, replace appropriate power window switch.
| Application & Position | (1) Terminals No. | |||
|---|---|---|---|---|
| Front Passenger's Switch | ||||
| UP | 1 & 2; 3 & 4 | |||
| OFF | 1 & 2; 3 & 5 | |||
| DOWN | 1 & 4; 3 & 5 | |||
| Rear Switches | ||||
| UP | 1 & 2; 3 & 4 | |||
| OFF | 1 & 2; 3 & 5 | |||
| DOWN | 1 & 4; 3 & 5 | |||
|
||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.