1998 Chevrolet Prizm LSi, StandardFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Accessory Power Relay Junction Block No. 1
Connector
C204 Behind Left "B" Pillar Trim Panel
C206 Behind Left Kick Panel
C207 Behind Left Kick Panel
C216 Behind Right Kick Panel
C217 Behind Right "B" Pillar Trim Panel
G200 Behind Left Kick Panel
P500 Behind Left "A" Pillar Trim Panel
P600 Behind Right "A" Pillar Trim Panel
P700 Behind Left "B" Pillar Trim Panel
P800 Behind Right "B" Pillar Trim Panel
SP252 Behind Instrument Cluster Assembly
Fuse
ECU-IG Junction Block No. 2
Gauge Junction Block No. 2
Power Junction Block No. 2
Junction Block
No. 1 Behind Left Kick Panel
No. 2 Left Instrument Panel, Behind Storage Box Cover
Power Window Motor In Respective Door, Behind Trim Panel, Near Armrest
Power Window Master Switch In Left Front Door, In Armrest
Power Window Switch In Respective Door, In Or Near Armrest
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.