Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Metro BaseFACTORY OEM SERVICE PROCEDURE
Ignition Timing
- Start engine and allow it to reach normal operating temperature. Ensure all accessories and A/C (if equipped) are turned off, and transaxle is in Park (A/T) or Neutral (M/T) with parking brake fully applied. Ensure idle speed is within specification. Adjust idle speed first if not within specification. See IDLE SPEEDΒ under IDLE SPEED & MIXTURE.
- Connect timing light to No. 1 spark plug wire. Remove cap from 6-pin duty check DLC located in rear corner of engine compartment, near left strut tower. Connect a fused jumper wire between terminals "D" and "E" of duty check DLC. See Fig 1.
- Check timing mark on crankshaft pulley with timing marks on timing belt cover. See Fig 2. Notch on crankshaft pulley should line up with appropriate degree mark on timing indicator as specified by underhood emission label.
- If ignition timing is not as specified, loosen distributor hold-down flange bolts, and rotate distributor to obtain correct ignition timing. Tighten distributor hold-down flange bolts to 11 ft. lbs. (15 N.m). Recheck ignition timing. Turn engine off. Remove jumper wire, and install cap on duty check DLC. Remove test equipment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
