1998 Chevrolet Metro BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
Audio Alarm Module Behind dash, left of steering column.
Daytime Running Lamps (DRL) Control Module Behind left side of dash.
Diode Module Behind center of dash, taped to harness.
Electronic Brake Control Module (EBCM) Behind left side of dash, above junction block.
Ignition Control Module (1.0L VIN 6) Left side of firewall. See Figure.
Illumination Controller Behind dash, left of steering column.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Behind center console, forward of manual selector lever.
Power Door Lock Control Module Behind left side of dash, on "A" pillar.
Powertrain Control Module (PCM) Behind right side of dash, near glove box.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.