Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Lumina BaseFACTORY OEM SERVICE PROCEDURE
Transmitter Programming
NOTE:
Following procedure must be performed when replacing RKE module or either transmitter.
- Open trunk lid. Remove right side rear compartment trim. Using a jumper wire with alligator clips ground transmitter program wire terminal. Door locks will lock and unlock, indicating receiver is in program mode. See Fig 1 .
- Depress and hold LOCK and UNLOCK buttons simultaneously for 10 seconds. Door locks and trunk lid release should activate in about 2 seconds. First transmitter is now programmed. Repeat this step using other transmitter. If only one transmitter is being used, disconnect jumper wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.