Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
A linear Exhaust Gas Recirculation (EGR) valve is used on this system. Powertrain Control Module (PCM) commands EGR valve to operate when necessary by controlling a ground signal through PCM. This can be monitored on a scan tool by selecting DESIRED EGR POSITION function. Ignition voltage is supplied to EGR valve thorough a fuse. PCM monitors results of its command through a feedback signal. Feedback signal is the actual position of the EGR pintle. This feedback signal can also be monitored on a scan tool by selecting ACTUAL EGR POSITION function. The ACTUAL EGR POSITION should always be near the commanded or DESIRED EGR POSITION.
Conditions for setting this DTC are as follows:
- DTC(s) P0106, P0107, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0200, P0300-P0304, P0335, P0502, P0506, P0507 and P1441 not set.
- Engine speed is 900-1700 RPM (A/T).
- Engine speed is 1000-2200 RPM (M/T).
- ECT greater than 167°F (75°C).
- BARO greater than 72 kPa.
- MAP is 12-32 kPa.
- TP angle less than one percent.
- Vehicle speed is greater than 20 MPH.
- EGR flow restricted.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.