Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Cavalier RS, AutomaticFACTORY OEM SERVICE PROCEDURE
Left Front Window Does Not Operate
- Turn ignition switch to RUN position. Using DVOM connected to ground, measure voltage at master window switch connector (C1 on 4 door models) Brown wire terminal. See WIRING DIAGRAMS . Press left front window switch to DOWN position. If battery voltage is present, go to next step. If battery voltage is not present, go to step 4).
- Using DVOM connected to ground, measure voltage at master window switch connector Dark Blue wire terminal. Press left front window switch to UP position. If battery voltage is present, go to next step. If battery voltage is not present, go to step 4).
- Disconnect left front window motor harness connector. Using DVOM connected to ground, measure voltage at right window motor harness connector Brown wire terminal. Press left front window switch to DOWN position. If battery voltage is present, go to step 5). If battery voltage is not present, go to step 6).
- Replace master window switch. Recheck system operation.
- Using DVOM connected to ground, measure voltage at left front window motor connector Dark Blue wire terminal. Press left front window switch in UP position. If battery voltage is present, go to step 7). If battery voltage is not present, go to step 8).
- Repair open in Brown wire between master window switch and left front window motor. Recheck system operation.
- Replace left front window motor. Recheck system operation.
- Repair open in Dark Blue wire between master window switch and left front window motor. Recheck system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.