1998 Chevrolet Camaro V6-3.8L VIN KFACTORY OEM SERVICE PROCEDURE

Cruise Control Module: Service and Repair

REMOVAL PROCEDURE

Factory service manual diagram



1. Raise and suitably support the vehicle.
2. Remove the left front bumper fascia lower deflector.
3. Remove the cruise control module cover.
4. Disconnect the electrical connector from the cruise control module.

Factory service manual diagram



5. Disconnect the cruise control cable connector from the brake pipe clip.
6. Disconnect the cruise control cable from the cruise control module.

Factory service manual diagram



7. Remove the cruise control module bracket bolts (1 and 2).
8. Remove the cruise control module and bracket from the left side engine compartment inner rail.

Factory service manual diagram



9. Remove the cruise control module to bracket bolts.
10. Remove the cruise control module from the bracket.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Connect the cruise control module to the bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the cruise control module to bracket bolts.

Tighten
Tighten the cruise control module to bracket bolts to 4.5 N.m (40 lb in).

Factory service manual diagram



3. Install the cruise control module and bracket to the left engine compartment inner rail.
4. Install the cruise control module bracket bolts (1, 2).

Tighten
^ Tighten the cruise control module bracket bolts (1) to 10 N.m (89 lb in).
^ Tighten the cruise control module bracket bolt (2) to 2.0 N.m (18 lb in).

5. Connect the cruise control cable to the cruise control module.

Factory service manual diagram



6. Connect the cruise control cable clip to the brake pipe clip.
7. Connect the electrical connector to the cruise control module.

Factory service manual diagram



8. Install the cruise control module cover.
9. Instal the left front bumper fascia lower deflector.
10. Lower the vehicle.
11. Adjust the cruise control cable as needed. Refer to Cruise Control Cable Adjustment. Adjustments
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.