Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Chevrolet Camaro SS, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE
DTC 12: Diagnostic System Check: Testing
- Turn ignition switch to RUN position. If SECURITY indicator illuminates, go to next step. If SECURITY indicator does not illuminate, go to step 3).
- Attempt to enter BCM diagnostic mode. If SECURITY indicator flashes DTCs, system is operating properly.
- Turn ignition switch to OFF position. Disconnect BCM Blue, 32-pin connector C3. Connect a fused jumper wire between BCM connector C3, terminal C12 (Gray wire) and ground. If SECURITY indicator illuminates, go to next step. If SECURITY indicator does not illuminate, go to step 5).
- Check for a poor connection at BCM connector C3 terminal C12 (Gray wire). Repair as necessary. If connection is okay, replace BCM. See REMOVAL & INSTALLATION .
- Disconnect instrument cluster Black 34-pin connector. Connect a test light between instrument cluster terminal A13 (Orange wire) and ground. If test light illuminates, go to next step. If test light does not illuminate, go to step 7).
- Check for an open or poor connection in Gray wire between instrument cluster and BCM. If circuit is okay, service instrument cluster. See INSTRUMENT PANEL article.
- Repair open in Orange wire between instrument cluster and instrument panel fuse block.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.