Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Chevrolet Venture LSFACTORY OEM SERVICE PROCEDURE
CTD Shock Sensor Control Modes: Notes
- Remove BCM PRGRM fuse located in instrument panel fuse block. Turn ignition to ACCESSORY position. Seat belt warning light flashes and chime sounds 2-4 times to indicate vehicle is in customization mode.
- Each time the headlight and instrument panel light dimmer switch is turned on, the seat belt warning light will flash and chime will sound to indicate current customization mode. When Mode 4 is reached, Mode 1 will be repeated. To exit and save current customization mode, turn ignition off. Replace BCM PRGRM fuse.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.