1997 Chevrolet Cavalier Z24, AutomaticFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
A/C Compressor Relay Left Center Of Engine Compartment
A/C Pressure Sensor Right Side Of Engine Compartment
Camshaft Position (CMP) Sensor Right Rear Of Engine
Convenience Center Right Upper Side Of Instrument Panel
Cooling Fan Relay Left Center Of Engine Compartment
Crankshaft Position (CKP) Sensor Rear Center Of Engine
Cruise Control Module Top Center Of Engine Compartment
Data Link Connector (DLC) Lower Left Side Of Instrument Panel
EGR Valve Left Front Of Engine
Electronic Ignition Control Module Rear Center Of Engine
Engine Coolant Level Switch Right Side Of Engine Compartment
Engine Coolant Temperature (ECT) Sensor Left Front Of Engine
Engine Oil Pressure Sensor Left Rear Of Engine
EVAP Canister Purge Solenoid Rear Center Of Engine
EVAP Canister Vent Solenoid Right Front Of Engine Compartment
Fuel Injectors Left Top Of Engine On Fuel Rail
Fuel Pump Relay Left Center Of Engine Compartment
Fuel Tank Pressure Sensor Front Of Fuel Tank
Idle Air Control (IAC) Valve Left Top Of Engine
Intake Air Temperature (IAT) Sensor Top Of Engine On Air Intake Duct
Knock Sensor Rear Center Of Engine
Manifold Absolute Pressure (MAP) Sensor Left Top Of Engine
Oxygen Sensors (O2S)
Pre-Converter Left Rear Of Engine Compartment In Left Exhaust Manifold
Post-Converter Under Rear Passenger Compartment, Rear Of Catalytic Converter
Powertrain Control Module (PCM) Right Front Corner Behind Fascia
Throttle Position (TP) Sensor Left Side Top Of Engine
Transaxle Range Switch Left Rear Of Engine
Underhood Fuse/Relay Center Left Center Of Engine Compartment
Vehicle Speed Sensor
A/T Left Rear Of Transaxle
M/T Rear Center Of Engine
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.