Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Chevrolet Forward Control 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Starter Specifications
PULL-IN WINDINGS SPECIFICATIONS
| Engine | Starter Motor | Amps | |||||
|---|---|---|---|---|---|---|---|
| Gasoline Models | |||||||
| Standard | SD260 | (1) 60-85 | |||||
| Optional | PG260 | (2) | |||||
| Diesel | 28MT | (1) 52-59 | |||||
|
|||||||
STARTER NO-LOAD TEST SPECIFICATIONS
| Application | Starter | (1) Amps | RPM | ||
|---|---|---|---|---|---|
| Gasoline Models | SD260 | 50-62 | 8500-10,700 | ||
| Diesel | 28MT | 130-190 | 2300-5600 | ||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.