Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995FORWARD CONTROL 7.4 NREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - 4.3LTROUBLE CODE CHARTSCODE 72, VSS CIRCUIT LOSS TRANS OUTPUT SIGNAL - ALL MODELSNOTES
1995 Chevrolet Forward Control 7.4 N
Code 72, VSS Circuit Loss Trans Output Signal - All Models: Notes
1995 Chevrolet Forward Control 7.4 NSECTION Notes
VSS output sensor is a magnetic induction type. Gear teeth pressed on outside diameter of output carrier assembly induce an alternating current in sensor when drive wheels are turning.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Test verifies VSS voltage at control module.
- Test checks VSS buffer ground circuit.
- Test checks VSS circuit at buffer module.
- Test verifies VSS signal at sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.