Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Chevrolet Cavalier Base, 2.2 4FACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes - 2.2L
- Introduction
- Self-Diagnostic System
- ECM/Pcm Code Charts
- Notes
- Code 13, Open Oxygen Sensor Circuit
- Code 14, Coolant Temperature Sensor Signal Voltage Low
- Code 15, Coolant Temperature Sensor Signal Voltage High
- Code 19, Intermittent 7X Signal
- Code 21, Throttle Position Sensor Signal Voltage High
- Code 22, Throttle Position Sensor Signal Voltage Low
- Code 23, Mat Sensor Signal Voltage High
- Code 24, Vehicle Speed Sensor
- Code 25, Mat Sensor Signal Voltage Low
- Code 26, Quad-Driver Error
- Code 27, Quad-Driver No. 1 Error
- Code 28, Quad-Driver No. 2 Error
- Code 32, EGR System Error
- Code 33, Map Sensor Signal Voltage High
- Code 34, Map Sensor Signal Voltage Low
- Code 35, IAC Idle Speed Error
- Code 43, ESC Error
- Code 44, Lean Exhaust Indication
- Code 45, Rich Exhaust Indication
- Code 55, Fuel Lean Monitor
- Code 66, A/C Pressure Sensor
- Summary
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
