1993 Chevrolet Camaro Base, StandardFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft/ Lbs. (N.m)
Ball Joint Stud Nut (1)
Lower 81 (110)
Upper 39 (53)
Coil Spring/Shock Assembly
Upper Shock Bolt 37 (50)
Upper Shock Nut 32 (43)
Lower Shock Mount Bolt 48 (65)
Hub & Bearing Assembly Bolt 63 (85)
Lower Control Arm-To-Crossmember Bolt/Nut
Front 74 (100)
Rear 85 (115)
Stabilizer Bar
Insulator Clamp Bolt (At Frame) 41 (56)
Linkage Bolt/Nut (At Control Arm) 17 (23)
Tie Rod End Nut (1) 35 (47)
Upper Ball Joint-To-Control Arm Nut (2)
Upper Control Arm-To-Arm Support Bolt/Nut 72 (98)
Wheel Lug Nut 100 (136)
(1) Always tighten nut to align cotter pin slot; DO NOT loosen nut.
(2) Use specification provided with replacement ball joint.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.