1992 Chevrolet APVFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor Clutch Diode Taped to wiring harness, next to A/C clutch connector.
ALDL Diagnostic Connector
3.1L (VIN D) Under left side of dash, left of steering column. See Figure .
3.8L (VIN L) Under left side of dash, left of steering column. See Figure .
Blower Motor Resistor
Auxiliary Below heater module assembly, mounted to floor duct outlet.
Main In engine compartment, mounted on A/C-heater module assembly.
DRL Diode In engine compartment, above left wheelwell.
Fuel Pump Prime/Test Connector
3.1L In engine wiring harness, behind battery. See Figure .
3.8L In left front corner of engine compartment. See Figure .
Set Timing Connector In engine compartment, above right wheelwell. See Figure .
Vehicle Speed Sensor Buffer Behind right side of dash, above convenience center. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.