1991 Chevrolet APVFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor Clutch Diode Taped to wiring harness, next to A/C clutch connector.
ALDL Diagnostic Connector Under left side of dash, left of steering column. See Figure .
Blower Motor Resistor In engine compartment, mounted on A/C-heater module assembly. See Figure .
Convenience Center Under right side of dash. See Figure .
Courtesy Light Diode On top of left "B" pillar, taped to courtesy light harness.
Fuel Pump Test Connector In engine wiring harness, behind battery. See Figure .
Set Timing Connector In engine compartment, above right wheelwell. See Figure .
Solenoid Box Behind right side of dash, mounted to A/C-heater box.
Vehicle Speed Sensor Buffer Behind right side of dash, above convenience center. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.