Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Chevrolet Corvette Base, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes
- Introduction
- Self-Diagnostic System
- Notes
- Hard Failures
- Intermittent Failures
- Diagnostic Procedure
- Retrieving Codes (Non-Scan)
- Reading Trouble Codes
- Trouble Code Definition
- Hard Or Intermittent Trouble Code Determination
- Clearing Trouble Codes
- ECM/Pcm Location
- Diagnostic Materials
- Special Tools (Diagnostic)
- Scan Tester Usage
- Scan Data
- Test Procedure Summary
- Diagnostic Tests
- Notes
- Code 13, Open Oxygen Sensor Circuit
- Code 14, Coolant Temperature Sensor Signal Voltage Low
- Code 15, Coolant Temperature Sensor Signal Voltage High
- Code 21, Throttle Position Sensor Signal Voltage High
- Code 22, Throttle Position Sensor Signal Voltage Low
- Code 23, Mat Sensor Signal Voltage High
- Code 24, Vehicle Speed Sensor (VSS)
- Code 25, (IAT) Mat Sensor Signal Voltage Low
- Code 33, Map Sensor Signal Voltage High
- Code 34, Map Sensor Signal Voltage Low
- Code 41, Cylinder Select Error
- Code 42, Est Circuit Open Or Grounded
- Code 43, ESC Error Without ESC Module
- Code 44, Lean Exhaust Indication
- Code 45, Rich Exhaust Indication
- Code 46, Pass-Key System
- Code 51, Faulty Prom/Mem-Cal
- Code 52, Low Engine Oil Temperature
- Code 53, System OVERVOLTAGE
- Code 54, Fuel Pump Voltage Low
- Code 62, High Engine Oil Temperature
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.