1990 Chevrolet Blazer 5.7 K, StandardFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor (Cts)

The CTS is a thermistor (temperature sensitive resistor) located in an engine coolant passage. The ECM supplies and monitors a 5-volt signal to CTS. This monitored 5-volt signal is then reduced by resistance of the CTS. When coolant temperatures are low, CTS resistance is high and a high monitored voltage signal is seen by the ECM. When coolant temperatures are high, CTS resistance is low and a low monitored voltage is seen by the ECM. When fully warmed, CTS should reflect a temperature of at least 185Β°F (85Β°C).

Coolant temperature input is used in the control of fuel delivery, ignition timing, idle speed, emission control devices and converter clutch application. A CTS which is out of calibration will not set a trouble code, but can cause fuel delivery and driveability problems. A coolant sensor circuit problem should set a related trouble code.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.