1990 Chevrolet APVFACTORY OEM SERVICE PROCEDURE

Code 23: Mat Signal Temp Low (2.5L): Notes

The ECM supplies and monitors a voltage signal (4-6 volts) to the sensor. When temperatures are low, sensor resistance is high and the ECM will see a high-monitored voltage signal. As temperature increases, sensor resistance decreases and voltage sensed by the ECM drops.

NOTE: Test numbers refer to test numbers on diagnostic chart.

Test Number 1)  This checks if Code 23 is a hard failure or an intermittent condition. Code 23 will set if engine is running for one minute, MAT sensor temperature is less than -22°F (-30°C) and speed sensor signal is not present.

Test Number 2)  This simulates conditions for a Code 25. If the "Scan" tester displays a high temperature, the ECM and wiring are not at fault.

Test Number 3)  This checks for continuity of sensor signal and ground circuits.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.