1990 Chevrolet APVFACTORY OEM SERVICE PROCEDURE

Speedometer Is Inaccurate & ECM Code 24 Is Set

  1. Turn ignition on. Connect voltmeter between terminal "A" (Pink/White wire) of VSS buffer connector C1 and ground. If battery voltage is present, go to next step. If battery voltage is not present, repair open in Pink/White wire.
  2. Connect voltmeter between terminals "A" (Pink/White wire) and "B" (Black wire) of VSS buffer connector C1. If battery voltage is present, go to next step. If battery voltage is not present, repair open in Black wire.
  3. Turn ignition on. Place transaxle in Neutral. Raise drive wheels. Set voltmeter on AC scale. Measure voltage between terminals "A" (Purple wire) and "C" (Yellow wire) of VSS buffer connector C2 while rotating drive wheels by hand. If voltage varies between zero and one volt, check connectors C1 and C2. If connectors are okay, replace VSS buffer. If voltage remains at zero volt, check for open circuit in Yellow or Purple wire. If wire is okay, replace VSS.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.