1990 Chevrolet APVFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor Clutch Diode Taped to wiring harness, next to A/C clutch connector.
ALDL Diagnostic Connector Under left side of dash, left of steering column. See Figure .
Blower Motor Resistor In engine compartment, mounted on A/C-heater module assembly. See Figure .
Convenience Center Under right side of dash. See Figure .
Courtesy Light Diode On top of left "B" pillar, taped to courtesy light harness.
Daytime Running Light (DRL) Diode In engine compartment, above left wheelwell.
Fuel Pump Test Connector In engine wiring harness, behind battery. See Figure .
Set Timing Connector In engine compartment, above right wheelwell. See Figure .
Solenoid Box Behind right side of dash, mounted to A/C-heater box.
Vehicle Speed Sensor (VSS) Buffer Behind right side of dash, above convenience center. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.