Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chevrolet Spectrum ExpressFACTORY OEM SERVICE PROCEDURE
Test 7 - Fuel-Cut System Operational Check
- Warm engine until choke is fully open, A/C off and connect tachometer. Connect voltmeter between ground and terminal A (Black/Green wire) of fuel-cut relay See Fig 1 .
- Open throttle slightly and keep engine at 3500 RPM. Note voltage. If voltage is less than 6 volts, go to step 3). If voltage is greater than 6 volts, check for open between terminal A to ECM terminal No. 14. If wire is not open, adjust idle switch. If adjustment is okay, ECM or connection is faulty.
- Return throttle to idle and check voltage. If voltage changes, go to step 4). If voltage does not change, check adjustment of idle switch and A/C fast idle diaphragm.
- Voltage rises greater than 6 volts, then falls again to low level, when engine drops below 2000-2500 RPM. Fuel-cut circuit and idle switch adjustment are okay. If A/C equipped, repeat test with A/C on.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
