1987 Chevrolet Hi-Cube 6.2 J, 400/M40FACTORY OEM SERVICE PROCEDURE

Sending Units/Sensors

SENDING UNITS/SENSORS LOCATION

Component Location
Coolant Temp. Sending Unit/Switch On left of engine.
Coolant Temperature Sensor In right front corner of intake manifold.
Detonation (Knock) Sensor (ESC) On lower left side of engine block.
Engine Speed Sensor (6.2L) On top of vacuum pump.
MAP Sensor (Diesel) On right firewall in engine compartment.
MAP Sensor (Gas) On top right side of engine. See Figure.
Oil Pressure Sending Unit/Switch On top rear of block.
Oxygen Sensor In exhaust manifold.
Throttle Position Sensor (Gas) On throttle linkage. See Figure.
Throttle Position Sensor (Diesel) On pump throttle valve. See Figure.
Vehicle Speed Sensor In instrument panel behind speedometer.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.