1987 Chevrolet Chevette L4-98 1.6LFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor: Service and Repair


The following procedure should be performed with engine temperature over 120°F, otherwise the oxygen sensor may be difficult to remove.
1. Disconnect battery ground cable.
2. Disconnect oxygen sensor electrical connector, then remove sensor.
3. Reverse procedure to install. Torque sensor to 30 ft. lbs. Replacement sensors should have a special anti-seize compound applied to threads. If a replacement sensor is lacking anti-seize compound or original sensor is to be reinstalled, coat threads with suitable anti-seize compound.



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.