Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Chevrolet Chevette 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Feedback Carburetor Tests W/Codes
- Model Identification
- Description
- Diagnostic System Operation
- Basic Diagnostic Procedure
- Entering Or Exiting Diagnostic Mode
- Clearing Trouble Codes
- Reading Trouble Codes
- Trouble Code Component Identification
- Trouble Code Determination (Hard Or Intermittent)
- Diagnostic Materials
- Diagnostic Tools
- Diagnostic Circuit Check
- System Performance Check
- Chart A1 - Dwell Fixed Between 10Β°-50Β°
- Chart A2 - Dwell Fixed Over 50Β°
- Chart A3 - Coolant Sensor Circuit Check
- Chart A4 - "Check Engine" Light Inoperative
- Chart A5 - TPS Enrichment Check
- Chart A6 - Won't Flash Code 12
- Code 12 - No Distributor Reference Pulse To ECM
- Code 15 - Coolant Sensor Circuit Open
- Code 21 - TPS Circuit High
- Code 23 - M/C Solenoid Circuit Low
- Code 44 - Lean Exhaust Indication
- Code 45 - Lean Exhaust Indication
- Code 51 - Faulty Prom
- Chart C1 - ECM Replacement Check Chart
- Chart C2A - Stepped Speed Control (SSC) W/ A/C & A/T
- Chart C2B - Stepped Speed Control (SSC) W/ A/C & A/T
- Chart C2C - Stepped Speed Control (SSC) P/S Circuit
- Chart C2D - Stepped Speed Control (SSC) With M/T
- Chart C4D - Ignition System Check
- Chart C6A - Air Management Check
- Chart C7C - EGR Valve Check (Non ECM Controlled)
- Chart C9D - EFE Circuit Check
- Component Locations
- ECM Terminal Identification
- Wiring Diagram
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
