SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987ASTRO VAN CARGO, 4.3 Z, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWINDOW MOTORS & REGULATORSPOWER WINDOWSTROUBLE SHOOTINGPASSENGER'S WINDOW WILL NOT WORK
1987 Chevrolet Astro Van Cargo, 4.3 Z, Standard

Passenger's Window Will Not Work

1987 Chevrolet Astro Van Cargo, 4.3 Z, StandardSECTION Passenger's Window Will Not Work
  1. With ignition switch in "RUN" or "ACC" position, check for voltage at passenger's switch. If there is no voltage, find open between switch and fuse block. If okay, go to next step.
  2. With voltage applied to Pink wire at the switch, move switch to the "UP" position. Dark Blue wire should also have voltage. If there is no voltage, replace switch. If okay, go to next step.
  3. With power window switch in the "UP" position, check for voltage on Dark Blue wire at power window motor. If there is no voltage, find open between switch and motor.
  4. If there is voltage on Dark Blue wire, connect a grounded jumper wire to Brown wire at the motor. If motor runs, find open in ground circuit. If motor does not run, replace power window motor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.