1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Evaporation System: Operation

When the engine is not running, purge valve opens fuel tank vapor line to canister and switch vent solenoid opens float bowl vent to canister.

When the engine is running and warmed to normal operating temperature, bi-metallic vacuum switching valve (BVSV) closes and allows a carburetor vacuum signal to open purge control valve. With the purge valve open, manifold vacuum draws canister vapors into combustion chambers for burning.

The two-way check valve is used to balance vapor pressure between fuel tank and canister.

Fig 1: Fuel Evaporation System
G37887
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.