1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

EGR Modulator Check

  1. Check EGR modulator filter for contamination or damage. Clean filter with compressed air.
  2. With engine off, disconnect modulator vacuum hoses (2). Plug one nozzle with finger and blow compressed air into other nozzle. Check that air passes through filter. See Fig 1 .
  3. Warm engine to normal operating temperature. Run engine at 5000 RPM. Using finger, plug one nozzle on modulator. Blow compressed air into other nozzle on modulator.
  4. Check that there is strong resistance to airflow. Reconnect vacuum hoses to each nozzle.
Fig 1: Checking EGR Modulator
G36521
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.