1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

PCV Valve

CAUTION: Do not suck air through the PCV valve. The fuel vapor and petroleum substances inside the PCV valve are harmful.
  1. Disconnect PCV hose at breather hose and run engine at idle. Place finger over end of PCV hose and check that there is vacuum. If not, check hose and PCV valve for clogging. Replace PCV valve and/or hose if clogged and retest.
  2. With engine off, remove hose from PCV valve and install a new hose on PCV valve. Blow air into hose and check that air flows with difficulty through PCV valve into intake manifold. If air flows easily through PCV valve, replace PCV valve. Use sealing tape on threads when installing PCV valve in intake manifold.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.