Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE
Two-Way Check Valve
- Remove two-way check valve from vapor line and note color coded ports. Connect a new piece of hose to Orange valve port (canister side). Slowly blow air into hose and check that air flows out of Black port.
- Remove hose from valve and connect hose to Black valve port (tank side). Slowly blow into hose and check that air flows out of Orange port. Replace valve if it does not operate as outlined.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
