1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

Wide Open Throttle Micro Switch

  1. Remove air cleaner and carburetor. Connect ohmmeter to wide open throttle (WOT) micro switch. See Fig 1 . Check that resistance between micro switch terminals is infinity.
    Fig 1: Connecting Ohmmeter to WOT Micro Switch
    G42232
  2. Open throttle valve gradually until ohmmeter indicates zero. Using a vernier caliper, measure clearance between throttle valve and primary carburetor bore.
  3. Clearance should be .28-.33" (7.2-8.4 mm). If clearance is incorrect, bend WOT micro switch lever to adjust clearance. See Fig 2 .
Fig 2: Adjusting WOT Micro Switch Lever
G42233
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.