Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor
- Warm engine to normal operating temperature. Disconnect oxygen sensor connector.
- Connect digital voltmeter between oxygen sensor side terminal (of disconnected connector) and ground. See Fig 1 . DO NOTΒ apply voltage to oxygen sensor.
- With engine at 1500-2000 RPM, turn WOT micro switch "ON" by moving micro switch lever. See Fig 2 . Check that voltmeter reads about .8 volts.
- With engine at 1000-1500 RPM, disconnect Hot Idle Compensator vacuum hose at intake manifold. Check that voltmeter reads near zero. Reconnect vacuum hose and oxygen sensor connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
