Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE
Feedback System Check
- Turn "ON" cancel switch, located near fuse block, under left side of dash. See Fig 1 . Turn ignition switch "ON", but do not start engine. Oxygen sensor light in dash should light, but not flash.
- If oxygen sensor light does not operate, check light circuitry. Refer to Oxygen Sensor Signal Check section. After oxygen sensor light operates, warm engine to normal operating temperature.
- Run engine at 1500-2000 RPM and check that oxygen sensor light flashes. If it does not flash, check and adjust or replace the following: oxygen sensor, mixture control solenoid, carburetor idle mixture, thermal switch, electrical connections, ECM or micro switches.
- After making sure oxygen sensor light flashes, turn cancel switch "OFF". Oxygen sensor light should go out.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
