1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

ECM Power Circuits Check

  1. Disconnect ECM coupler. Turn ignition switch "ON", but do not start engine. Connect voltmeter between terminal No. 2 of disconnected coupler (on wiring harness side) and body ground. See Fig 1 . Check voltage.
    Fig 1: Checking Sprint ECM Power Circuits
    G42238
  2. Repeat voltage check for terminal Nos. 3, 9, 12, 13, 16 and 18. If measured voltage between each terminal and body is about 12 volts, each circuit is in good condition.
  3. Check clutch switch operation as follows: Connect voltmeter between terminal No. 13 and ground. Depress clutch pedal fully. Voltage should drop to zero, indicating clutch switch is "ON" and terminal is grounded. Reconnect coupler to ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.