1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE

ECM Ground Circuits Check

  1. To check that ECM is grounded to body and transaxle, turn ignition switch "OFF". Disconnect coupler from ECM (under left side of dash).
  2. Measure resistance between terminal No. 1 (Black wire) and body and terminal No. 19 (Black/Green wire) and body. If resistance is zero, ECM is properly grounded.
  3. If resistance is not zero, check body ground at left kick panel and transaxle ground near gear shift guide case. After ensuring ECM is grounded, reconnect ECM coupler.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.