Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Sprint AutomaticFACTORY OEM SERVICE PROCEDURE
Component Testing: Commutator
- Inspect commutator for roughness. If surface is pitted, stepped or grooved, it should be lightly sanded with No. 400 sandpaper. Check commutator for out-of-round.
- If out-of-round is more than .002" (.05 mm), turn the commutator on a lathe until out-of-round is within specification.
- Wear or cutting limit of commutator is 1.08" (27.5 mm) on Mitsuba starters, or 1.14" (29 mm) for all others.
- If worn less than .008" (.20 mm), insulating mica should be undercut to a depth of approximately .015-.031" (.40-.80 mm) on all models.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
