Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Spectrum 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications & Procedures: Adjustment: Toe-In
- Loosen right and left tie rod end lock nuts. Turn right and left tie rods by the same amount to align toe-in to specifications. Right and left tie rods should become equal in length.
- Tighten lock nuts and make certain rack boots are not twisted. Check toe-in.
NOTE:
When a tie rod or tie rod end is replaced, check toe and steering angle with turning radius gauges. If steering angle is not correct, check the right and left tie rods for equal length.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.