Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chevrolet Nova CL, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification |
|---|---|
| Camber (Degrees) Front | -0.25 +/- 0.5 |
| Camber (Degrees) Rear | -0.5 +/- 0.5 |
| Caster (Degrees) Front | +0.8 +/- 0.8 |
| Caster (Degrees) Rear | N/A |
| Toe-In (Inches) Front | +1/8 +/- 1/8 |
| Toe-In (Inches) Rear | +1/16 +/- 1/32 |
| Toe-In (Millimeters) Front | 0 +/- 0.5 |
| Toe-In (Millimeters) Rear | +3 +/- 1.5 |
| Toe-In (Degrees) Front | 0 +/- 1/16 |
| Toe-In (Degrees) Rear | +1/8 +/- 1/16 |
| Toe-Out On Turns Inner (Front) | 40Β° |
| Toe-Out On Turns Outer (Front) | 33Β° |
| Steering Axis Inclination (SAI) (Front) | N/A |
| Wheelbase Inches | 95 3/4 |
| Wheelbase Millimeters | 2431 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
