Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Purging Fuel Tank
Water in the fuel tank may be removed with a pump or by siphoning. The pump or siphon hose should be hooked up to the 1/4" fuel return hose above the rear axle or under the hood near the fuel pump. Continue siphoning until all water is removed. Use clear plastic line or observe filter bowl on draining equipment to determine when clear fuel begins to flow. Remove the cap on fuel tank when purging the tank and replace cap when finished. Use the same precautions for handling diesel fuel that you would use for purging gasoline fuel tanks.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.