Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1985 Chevrolet Corvette AutomaticFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application

Specification

Caster (Degrees)

⁽¹⁾ 3 +/- 1/2

Camber (Degrees)

Front

+ 3/4 +/- 1/2

Rear

0 +/- 1/2

Toe-in (Inches)

Front

+ 3/10° +/- 2/10°

Rear

3/10° +/- 1/10°

Toe-Out on Turns (Degrees)

Inner

N/A

Outer

N/A

⁽¹⁾	Maximum side-to-side difference 1/2°

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.