1985 Chevrolet Corvette AutomaticFACTORY OEM SERVICE PROCEDURE

Miscellaneous Components

MISCELLANEOUS COMPONENTS LOCATION

Component Location
A/C Compressor Clutch Diode Taped in A/C compressor connector.
A/C-Heater Blower Resistor On A/C-heater plenum, in engine compartment. See Figure.
Assembly Line Data Link Connector Under left side of dash.
Convenience Center Behind center of instrument panel. See Figure.
Fuse Block Under right side of dash. See Figure.
Fusible Links "A" & "B" (Red) At starter solenoid. See Figure.
Fusible Links "C" (Blue) At starter solenoid. See Figure.
Fusible Links "D" & "E" (Orange) In left rear corner of engine compartment, near battery.
Fusible Links "F" & "G" (Red) At connector, in left rear corner of engine compartment. See Figure.
Fusible Links "H" (Orange) In left rear corner of engine compartment, near battery.
Headlight Actuators Next to each headlight assembly.
Horn In-Line Fuse Behind center of instrument panel. See Figure.
Power Acc. Circuit Breaker In fuse block.
Power Window Circuit Breaker In fuse block.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.