1983 Chevrolet Sportvan G10, 5.7 LFACTORY OEM SERVICE PROCEDURE

Sending Units/Sensor Switches

SENDING UNITS/SENSOR SWITCHES LOCATION

Component Location
A/C Pressure Cycling Switch On accumulator drier. See Figure.
Detonation Sensor On lower left side of engine block behind starter.
Fuel Gauge Sender Top of fuel tank.
Oil Pressure Sensor (4.1L) In engine above starter.
Oil Pressure Sensor (5.0 & 5.7L) Left front of distributor.
Oil Pressure Sensor (6.2L) Upper front of engine.
Oxygen Sensor (6-Cyl.) In front exhaust pipe. See Figure, Figure & 9.
Oxygen Sensor (V8) In exhaust manifold. See Figure, Figure & 9.
Vacuum Sensor On firewall. See Figure.
Vehicle Speed Sensor Under left side of dash.
Water Temperature Switch (6-Cyl.) On water outlet. See Figure.
Water Temperature Switch (V8) On left rear corner of engine. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.