1983 Chevrolet Citation 2D Hatchback, 2.8 Z, AutomaticFACTORY OEM SERVICE PROCEDURE

Basic Diagnosis & Testing Information

Diagnosis of the CCC system is done in the following order:

  1. Ensure that all engine systems NOT related to the CCC are fully operational. DO NOT  proceed with testing unless you are sure all other problems have been fixed.
  2. Enter diagnostic mode and record trouble codes flashed by CHECK ENGINE" light. Exit diagnostic mode.
  3. Distinguish between "hard" or "intermittent" trouble codes.
  4. If trouble codes were displayed, go to Diagnostic Circuit Check chart. Follow instructions given there.
  5. If no trouble codes were recorded, go to Drive Complaint Sheet and follow instructions given there.
  6. After any repairs are made, perform System Performance Check. Clear any trouble codes.
NOTE: The following paragraphs explain the procedures involved in performing the steps outlined above.

The ECM stores component failure information for CCC system under a related trouble code which can be recalled for diagnosis and repair. When recalled, these codes will be displayed by flashes of CHECK ENGINE" lamp. Codes are displayed starting with lowest numbered code. Only codes in which a related malfunction has occurred will be displayed.

NOTE: Example of trouble codes is as follows: "FLASH", "FLASH", "FLASH", pause, "FLASH", "FLASH" followed by a longer pause identifies trouble code "32". First series of flashes indicates first digit of trouble code; second series of flashes indicates second digit of trouble code.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.