Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Chevrolet Camaro Base, 5.0 H, StandardFACTORY OEM SERVICE PROCEDURE
Front Internal Gear: Notes
- Install thrust washer on front internal gear and retain with petroleum jelly. Install front internal gear into case.
- Install rear unit selective thrust washer on top of internal gear thrust washer. Install output shaft-to-thrust washer snap ring and make sure snap ring is fully seated in output shaft groove.
- At this time, measure rear unit end play to ensure correct selective thrust washer has been installed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.