Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CAVALIER BASE, 4D SEDAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSCOMPUTER COMMAND CONTROLOPERATIONELECTRONIC CONTROL MODULE (ECM)MEMORIES
1982 Chevrolet Cavalier Base, 4D Sedan, Automatic Trans
Electronic Control Module (ECM): Memories
1982 Chevrolet Cavalier Base, 4D Sedan, Automatic TransSECTION Memories
The 3 types of memories in the ECM are: Read Only Memory (ROM), Random Access Memory (RAM) and Programmable Read Only Memory (PROM). Function of each memory is as follows:
- Read Only Memory (ROM) - The ROM is programmed information that can only be read by ECM. The ROM program cannot be changed. If battery voltage is removed, ROM information will be retained.
- Random Access Memory (RAM) - This memory is the scratch pad for the CPU. Information can be read into or out of RAM memory; similar to a calculator. Data sensor information, diagnostic codes and results of calculations are temporarily stored in RAM memory. If battery voltage is removed, all information stored in this memory is lost.
- Programmable Read Only Memory (PROM) - This memory is factory-programmed information containing engine calibration data for each engine, transmission, body and rear axle ratio application. The PROM is easily removed from ECM. If battery voltage is removed, PROM information will be retained.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.