Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1969 Chevrolet Impala 2D Convertible, 5.0L Eng, Not Available TransFACTORY OEM SERVICE PROCEDURE
Oil Pan Removal: Notes
- 1964 BUICK V6 & 300" V8 ENGINES OIL PAN ASSEMBLY CHANGE NOTE - Oil pan changed in production. Later type has lower oil sump level to improve engine efficiency at high speeds. When installing, pipe and flange assembly and dipstick must also be replaced with new type parts.
- 1964-65 BUICK OIL SEEPAGE AT ENGINE OIL PAN ATTACHING BOLTS CORRECTION (V6 & 300" V8): Some engine oil pan bolt holes are drilled through to crankcase and can allow seepage which may be mistaken for oil pan gasket leak. To correct, remove 3 or 4 bolts in leak area, and if holes are drilled through, apply sealer Gr. 8.800, Part 980032, or equivalent.
- EARLY 1964 CADILLAC OIL PAN SEAL LEAK CORRECTION: On cars before Engine Number 028370, a rear oil pan seal leak may be corrected by installing new oil pan gaskets and a 1/16-1/8" bead of Transmission Oil Cooler Hose Cement, Part No. 1098993, at top corners of oil pan.
- 1965-70 PONTIAC OIL PAN SEEPAGE V8 ENGINES - Even after normal procedures (replacing gaskets, checking bolt torque, etc.) have been followed, oil seepage may occur at the joint where the oil pan side rail gasket over-laps rear pan gasket. Oil pan reinforcement package (Part No. 484083) fits all 1965-70 V8 engines and will correct oil seepage.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.