2020 Cadillac CT6 LuxuryFACTORY OEM SERVICE PROCEDURE

Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

  1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
  2. Ignition - On / Vehicle - In Service Mode
  3. Perform the SPS function K69 Transfer Case Control Module - Programming

    Verify the control module programming is successful.

    • If the programming is not successful 
    1. Ignition/Vehicle - Off - For greater than 1 min
    2. Ignition - On / Vehicle - In Service Mode
    3. Perform the SPS function K69 Transfer Case Control Module - Programming
      • If the programming is not successful - Replace the component K69 Transfer Case Control Module
      • Go to next step: If the programming is successful
    4. Ignition/Vehicle - Off
    5. Wait 30 s before proceeding to the next step.
    6. Ignition On - Engine Running
    7. Clear DTCs.
    8. All OK.
    • Go to next step: If the programming is successful 
  4. Ignition/Vehicle - Off
  5. Wait 30 s before proceeding to the next step.
  6. Ignition On - Engine Running
  7. Clear DTCs.
  8. All OK.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.