Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Replace and Program Control Module or Reprogram Control Module - With Night Vision Camera Replacement
Reprogram the Night Vision Camera Control Module when the Night Vision Camera is replaced. If the same camera has been removed and installed, perform Night Vision Camera Control Module Learn .
To program a replacement or an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K172 Night Vision Camera Control Module - Setup to enable Night Vision Calibration. Refer to: Night Vision Camera Control Module Learn .
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
