2019 Cadillac XTS BaseFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application
Steering Column Dash Outer Seal Clamp
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Instrument Panel Cluster Trim Plate Bolt 2.5 N.m (22 lb in)
Intermediate Steering Shaft Lower Bolt 34 N.m (25 lb ft)
Intermediate Steering Shaft Upper Bolt
  • First Pass:
25 N.m (18 lb ft)
  • Final Pass:
180 - 195 degrees
Steering Column Bracket Bolt 3 N.m (27 lb in)
Steering Column Lower Trim Cover Fastener 1.5 N.m (13 lb in)
Steering Column Nut 22 N.m (16 lb ft)
Steering Column Telescope Actuator Bolt 5 N.m (44 lb in)
Steering Column Telescope Actuator Pivot Bolt 18 N.m (13 lb ft)
Steering Column Tilt Wheel Actuator Bolt 5 N.m (44 lb in)
Steering Column Tilt Wheel and Telescope Control Module Bolt 3 N.m (27 lb in)
Steering Wheel Bolt 45 N.m (33 lb ft)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.